Should I Replace Rg59 With Rg6

More Answers On Should I Replace Rg59 With Rg6

Should I replace rg59 with rg6? – AskingLot.com

Yes, RG6 is better than RG59, because RG59 has higher loss. The difference becomes more important at higher frequencies, and that is why satellite systems need RG6. However, there is no meaningful difference between analog and digital. can rg59 be used for HDTV? RG59 is meant to use for short runs, while RG6 is used to long runs.

Should I replace any RG59 cable I have with RG6?

RG-6 is absolutely recommended for satellite. I would never use RG-59 for any application. It is still ok for things like analog video cameras and other applications that use relatively low frequencies (think VHF, FM radio, etc). If I was replacing or installing new cable it would definitely be RG-6 or better.

Worth replacing 30 year old RG59 coaxial cable with new RG6 coaxial …

All cable companies use RG6 as their standard because it has wider bandwidth and less loss than brand new RG59. A 30 year old cable has aged enough to lose some signal too. Replacing it would be a…

RG6 vs RG59: Difference Between Two Coax Cables

May 10, 2021The inner conductor of RG59 cables is a thin – 20 AWG copper centre. This makes its diameter smaller than RG6. The frequency range is lower. RG6 can work even with 3Ghz, but RG59 may start showing inefficiency upon touching 2 GHz. If you need to work below 50 Mhz, RG59 is the way to go. RG6 provides lower attenuation when compared to RG59.

Replacing RG59 with RG6 cable – AVS Forum | Home Theater Discussions …

A quick search taught me that RG59 is not the best for HD signals, so I figured I would replace all the old cable with quad shielded RG6 while I was at it. A little bit about my set up. Like I said, the cable modem has a separate feed to it, so this would be for the TVs and cable tuners only. The TV cable splits 3 ways after an amplifier.

RG-6 vs RG-59 | A Brief Discussion and Comparison – TechDim

Jan 30, 2021For long-distance, RG-6 is better than RG-59 because RG-6 has a long diameter and is made for a long transmission line. So it has signal loss but that is ok as it covers a long distance. The RG-59 works for a small distance so it is ok when the distance is not long. In that case, the distortion or signal loss is less.

OK to mix RG6 and RG59 cables? – AVS Forum

RG59 has a little higher loss than does RG6 (~1.5dB/100’@1000MHz), so unless you’re talking significant lengths, you should have no problem. Coaxial cable doesn’t care if it is analog or digital. CIAO! Ed N. Save Reply S skunker Registered Joined Jan 1, 2008 88 Posts Discussion Starter · #4 · Feb 15, 2009 Thanks for the feedback.

Replace RG59 cable or keep? – DoItYourself.com Community Forums

Communications: Voice, Radio, Data Transfer Products and Devices – Replace RG59 cable or keep? – Is the increased performance of RG6 cable such that it is worthwhile to replace the old RG59? (Assuming there is a performance increase.) My situation is this: My two story house was built with RG59 ~ 15 years ago. I am

What is the difference between RG59 and RG6? – Sewell Direct

RG 59 is generally better for most CCTV systems and other analog video signals. What you really need to consider are the frequency ratings your equipment uses. If your equipment uses higher frequencies (above 50 MHz), then you’ll want to go with RG 6. If your frequencies are lower than that, then you’ll want to use RG 59. RG 59 (In-Depth)

RG59 or RG6 coax – Red Wave Radio

> >scanners, which is best to use the RG6 or RG59. As I understand the RG6 > >is 72 ohm coax and scanners should use 50 ohm cable. The cable run from > >radios to antennas if less than 50 feet. What’s the better choice ? > Actually, both coax cables are 72 ohm. I am not that familiar with the > RG6 but the RG59 is what is commonely used in …

How to distinguish between RG-59 and RG-6? – Home Theater Forum

Your coax is likely RG59 unless your house/apartment is fairly new. For about $12, Radio Shack sells a Coax Stripper with an adjustment to change from RG6 to RG59. In your case, start with the RG6 setting and try and strip the coax. If the cuts are not deep enough – this tells you it’s RG59. The twist-on connectors are a nice, tool-less way to go.

Is RG-6 coax cable better than RG-59 ? :: SG FAQ – SpeedGuide

Typical RG-6 Signal Loss per 100 ft: 50 MHz: 1.5 dB. 100 MHz: 2.0 dB. 400 MHz: 4.3 dB. 900 MHz: 6.8 dB. 1000 MHz: 7.0 dB. RG-59 cable. RG-59 is generally better for frequencies lower than 50 MHz, like CCTV systems. It is an older standard cable that was used for TV connections, however, it has a smaller conductor than RG-6, and its shielding is …

Is rg6 or rg59 better? – music – 2022

should I replace rg59 with rg6? Yes, RG6 is better than RG59, because RG59 has higher loss. The difference becomes more importantat higher frequencies, and that is why satellite systems need RG6. can rg59 be used for HDTV? RG59 is meant to use for short runs, while RG6 is used to long runs.

Once again…RG6 vs RG59/u – Audioholics Home Theater Forums

snickelfritz. Junior Audioholic. Oct 19, 2007. #2. RG6 is required for reliable digital connections; the bandwidth is wider with RG6. Satellite dish connections must use RG6 cable. I would also use RG6 for digital coax audio connections. RG59 is perfectly adequate for analog video connections and subwoofers.

What is the difference between RG59 and RG6? – ReadyToGoCables

RG 6 vs. RG 59 Applications RG 59 is usually better for most CCTV systems (Closed-circuit television) and other analog video signals. RG 6 is recommended for your TV antenna, satellite, or broadband internet. What you really need to analyze and take into consideration is the frequency ratings your devices utilize.

RG6 vs RG59: Difference Between Two Coax Cables

Mar 25, 2021The frequency range is lower. RG6 can work even with 3Ghz but RG59 may start showing inefficiency upon touching 2 GHz. If you need to work below 50 Mhz, RG59 is the way to go. RG6 provides lower attenuation when compared to RG59. This is a significant drawback for RG59 cables. Uses of RG6 vs RG59.

rg6 coax cable | rg59 cable | rg59 coaxial cable …

A basic rule of thumb is to use RG6 for any Rapid Frequencies, and use RG59 for video frequencies. RG6 has an aluminum braid and an aluminum shield. RG59 comes with a copper braid, and in some instances, an aluminum braid and shield, although this is quite rare. For any broadband CATV or satellite system, RG6 is recommended by all the experts.

螺裸 Should I replace rg59 with rg6?

Should I replace rg59 with rg6? RG59 will usually work. … RG59 is more lossy than RG6. RG59 is meant to use for short runs, while RG6 is used to long runs. 廊 Also know, is rg6 better than rg59? … RG-59/U is a specific type of coaxial cable, often used for low-power video and RF signal connections. The cable has a characteristic impedance …

Subwoofer cable with RG59 or RG6? | Home Theater Forum

There is not high voltage being carried from the receiver out to the sub input. Many interconnects are 22 to 30 ga. so RG-59 is more than adequate. There are also ltd. frequencies being carried to the sub. A Y connection. is not mandatory. If you want to use one they can be bought for just over $1 from places like:

RG 6 or RG59 TV cable? – AVForums

RG6 has a bigger diameter core, around 18AWG, a thicker dielectric and usually a 100% coverage foil shield which is then covered by 80 – 90% braided shield. Hence, it will offer a better performance than RG59. However, the correct (IMHO) cable to wire a house (for digital satellite or digital cable) is ‘CT100-spec’ cable.

Once again…RG6 vs RG59/u – Audioholics Home Theater Forums

snickelfritz. Junior Audioholic. Oct 19, 2007. #2. RG6 is required for reliable digital connections; the bandwidth is wider with RG6. Satellite dish connections must use RG6 cable. I would also use RG6 for digital coax audio connections. RG59 is perfectly adequate for analog video connections and subwoofers.

rg6 and rg59 coaxial cable? – DoItYourself.com Community Forums

Electrical – AC & DC – rg6 and rg59 coaxial cable? – hi does it cause any problems if you use rg6 and rg59 coaxial cable for tv, stereo in the same house, i re did a room, … Hi, I had to replace the light fixture on an outdoor light with a photo cell switch so that the light comes on automatically at dusk. I made a note of the way it was …

Using RG-59 or RG-6 CATV cable with an amateur radio antenna

Impedance mismatch of 75 Ohm Cable. RG-59 and RG-6 are 75 Ohm coaxial cables designed for cable television applications, they tend to have wide frequency response and low line loss. They also have an impedance of 75 ohms, which is a standard for coax cable used in the broadcast industry. You can use these cables with a 50 Ohm amateur radio …

How to distinguish between RG-59 and RG-6? – Home Theater Forum

Your coax is likely RG59 unless your house/apartment is fairly new. For about $12, Radio Shack sells a Coax Stripper with an adjustment to change from RG6 to RG59. In your case, start with the RG6 setting and try and strip the coax. If the cuts are not deep enough – this tells you it’s RG59. The twist-on connectors are a nice, tool-less way to go.

RG59 or RG6 coax – Red Wave Radio

> >scanners, which is best to use the RG6 or RG59. As I understand the RG6 > >is 72 ohm coax and scanners should use 50 ohm cable. The cable run from > >radios to antennas if less than 50 feet. What’s the better choice ? > Actually, both coax cables are 72 ohm. I am not that familiar with the > RG6 but the RG59 is what is commonely used in …

RG6/RG59 & Cable Modem | AnandTech Forums: Technology, Hardware …

Mar 28, 2005. #1. Hi all, I currently have RG59 in my house, and my cable modem randomly loses it’s connection to Road Runner. I also have ghosting and static on some channels so I figure it’s time to do something about it. I’m thinking about replacing the line to the cable modem with RG6 and getting rid of the old RG59.

Replacing old Coax Cable : HomeNetworking – reddit

The bigger the cable, the better. For home TV/Cable TV installs, RG6 (75 Ohm) is the standard. Don’t let someone talk you into RG-59. Also, Double shielded (foil+braid) is all you should buy. In my experience, The foil provides a major lifespan benefit as well as reduce electrical noise from getting in the line.

RG6 Install To Replace RG59 | DIRECTV Community Forums

Even though it’s only about a 55 foot run total, I’m going to replace the original RG59 I put into the house when built about ten years ago (kicking myself) with RG6 for the new AU9-S dish. … RG6 Install To Replace RG59. Welcome to the DIRECTV Community Forums – connect with users, ask questions, and find answers! A.

RG-6 vs RG-59 – Verizon Fios Community

If you have any problem with certain channels, especially those in the higher frequency range, replace the RG-59 with a run of RG-6. For whatever it’s worth, I have an old run of RG-59 going to one TV in our house. It’s about 50 feet long. The STB and TV it feeds work great except on channel 576, the HD Yankees channel.

Will coaxial cable degrade over time? – Amateur Radio Stack Exchange

A lot of hams will twll you that if you want to use RG-58 that instead you should use RG-8 (which is what PL-259 connectors are designed for. But hey, if that’s what you have on hand, by all means use it. BUT you probably will want new connectors. To use RG-58 or rg-59 in the PL-259 connectors, there are screw-in adapters to make it fit better …